I'm going to experiment myself but I figured it's good to ask since others probably have experience with this already. Grateful for any input!
amadama wrote:Is there a 1600x1200 mode (native resolution of my monitor)?
amadama wrote:I use my MISTer connected to either CRT VGA monitor or 4:3 1600x1200 LCD.
I don't have the I/O board (only SDRAM).
I use an HDMI to VGA adapter that has an audio output:
Works great for me and it's cheap. (about US $8)
I also use it for Raspberry PI and other SBC. For MISTer no need to connect the USB power, just plug the VGA and audio and it just works.
If using a 4:3 monitor make sure all cores you are running are set to 16:9 aspect ratio so they fill the screen.
BBond007 wrote:I just built up the analog audio circuit from the IO board schematic on a bread board with through-hole components. It was maybe 6 or so caps and a few resistors. (pic here: viewtopic.php?f=117&t=33895)
I have the audio out of the monitor connected to a switch box.I honestly can't tell the difference between the HDMI audio and the analog. I notice no crosstalk or noise. I don't know if I should expect less or more noise how I did it.
The BOOM Sorgelig spoke of when changing cores definitely happens but does not bother me even though I have a subwoofer connected. To me its more of a POP than BOOM.
It's definitely not like the Raspberry Pi where the analog audio is totally popping and hissing garbage compared to the HDMI output. I ended up putting a HiFiberry on that thing.
Users browsing this forum: No registered users and 1 guest