Moderators: Mug UK, Zorro 2, Greenious, spiny, Sorgelig, Moderator Team
rezb1t wrote:I wish I had a more concrete description of what is going on, but it is difficult to narrow down. I will continue to look for any more information and post back here.
jpxdude wrote:With the latest 20190609 core, I am getting an issue with inputs (only tested in SNES and GB so far). I am using an XBOX 360 Wireless controller with the official wireless dongle.
I've found that with the 'X' button on my controller held down, I cannot press any other button at the same time (B, Y, A, L, R).
For example, in Super Mario World, I would map the X button to Y in SNES, and hold this button to run, and press A (mapped as B in SNES) to jump, however if the X button is held down, no other button registers input. The only thing that works with the Y button held down is the directional pad.
Any help with this would be greatly appreciated. Thanks in advance.
Hewhoisred wrote:
I'm not sure this will help you but:
Navigate on your SD card to the config folder and clear out all the .map files for the problem core(s). Try a fresh remap and see if it improves.
rezb1t wrote:I wish I had a more concrete description of what is going on, but it is difficult to narrow down. I will continue to look for any more information and post back here.
digitron wrote:Per https://github.com/MiSTer-devel/Main_Mi ... ustomizing - "Press F1 once rebooted into MiSTer to select your background"
Does nothing, F1 doesn't bring up any form of menu to select new menu.jpg
djmartins wrote:digitron wrote:Per https://github.com/MiSTer-devel/Main_Mi ... ustomizing - "Press F1 once rebooted into MiSTer to select your background"
Does nothing, F1 doesn't bring up any form of menu to select new menu.jpg
It changes the background. aka wallpaper, by cycling through them, in MiSTer and does not bring up a new menu.
When in the main MiSTer menu a F12 brings up a menu where you can see your network IP and run scripts and F12
brings you back from there....
Sorgelig wrote:It's only for HDMI output (or VGA with vga_scaler=1)
Newsdee wrote:how about using up/down to select options after they are defined?