Sorgelig wrote:I don't want to comment each logo as it's matter of taste. If i will guide to much then we will come to the same log as current one.
While having a nice logo is good idea, it's not the priority task. I still look through all posted logos.
1) I think logo must be sketched, black and white only. So it can be used anywhere without modifications. For example on PCB where you can't use colours.
2) It should be simple so it can be easily scaled to different sizes. Complex logo will look like dirty spot when scaled down.
Basically i like the current MiSTer logo i'm using on PCB, but still open for a better one.
That's fine, I mean you never asked for this and nobody can demand feeback or attention from you, hence my question for clarification.
Would you want a new logo, then you would now need to pick your favorites and give us minimum dimensions so we can work on from there.
I think the logo does not need to be black and white per se, there only needs to be a black and white variant available (see the Raspberry Pi Logo).
But anyway, it is a just for fun thread and I had my fun. Thanks for clarifying!