I have trouble to get CT60e run in 060-mode. I'm able to boot 030-mode, but in 060-mode I got just black screen. It is kind of trying to do something: My multisync monitor makes noise when changing resolution and when booting in 060-mode Falcon changes resolution, but screen remains black.
Previously I was able to get it up and running lifting it up little bit and then putting it back in 'right' 'angle'. It has been like this since I got it, but situation went worse when time passed.
Just in case I have tested all easy ones: different power, cpu and memory. So looks like problem might be in CT60e itself or machine. I'm wondering if I have done something bad, like bend CT60e too much while removing it.
Machine does not have timing fix or bus acceleration.
Any suggestions what I should test next? Check/resolder connectors between Falcon and CT60e?