Sven wrote:1--Now with the new IDE drive I would like to know if it is possible to use both drives at a time to copy/move all files from the old hdd to the new IDE hdd or CF card ??
Sven wrote:2--Am I´m right that the one cable from the IDE controller that has to be attached to pin 10 on the ASCI port is only necessary if I want to have boot capability from the IDE drive ??
Sven wrote:3--Without TOS 2.06 I have to boot from floppy ??
joska wrote:CF-cards can be tricky. Try HD-Driver instead, it specifically supports CF-cards. There is a demo available on Uwe's website.
catmando wrote:Had to swap to an IDE to SD adapter (CBHD still wanted to only make one partition though when I tried it)
alanh wrote:These older IDE boards are not produced by me anymore. I now do the MonSTer board instead.
Users browsing this forum: No registered users and 8 guests