Dal wrote:Check my site for ideas:
http://www.septicsurgeon.net/Hardware_M ... on%29.html
I intend to take it very slowly, and to consult my friend who is much better with soldering than me. I will post pictures when I'm finished. Thanks again for advices! Atari-Forum is a great communityDal wrote:It would be great to see your finished solution. Have fun and take it slowly!
Dal wrote:Yes you got it. For the 520ST then there is no need to do the Floppy A/B switch mod as the external port is already mapped to Drive A (or DS0 to use its correct name).
So just wire up directly from the 34pin IDC header on the HxC to the 14pin DIN connector and you're good to go. If you want a completely internal solution (and you're able to desolder without destroying boards), you might consider removing the 14pin connector and wiring directly to the board or keep the connector in place but tap back to find a suitable place to take each line from.
saulot wrote:... I've read somewhere that standard psu isn't enough and you have to provide addtional power supply. Is this true?
Users browsing this forum: No registered users and 0 guests