DarkLord wrote: I really like the "this way up" part.
exxos wrote:one thing to note here, you have to fit the eproms direct into the sockets (hardware only) otherwise the ST metalwork will not sit flush, and this could prevent you from screwing the case back together and even cause the keyboard to be at the wrong angle. Note the metalwork rests directly ontop of the first TOS chip towards the edge of the board. So any additional sockets or such will cause a problem. While my TOS adapter PCB is a simple plugin, you will not be able to reassemble back into the ST case. So doing the wiring direct on the chip as I show on my pages is the only other "easy" solution.
DarkLord wrote:Coincidentally, there is another thread about this same subject (daughterboard on
NikiforosST wrote:Ready at last! working perfectly!
Original SHARP chips with TOS 1.02 (28 pins)
New eprom Chips with TOS 1.04 (32pins)
Users browsing this forum: No registered users and 1 guest