Jookie wrote:And how about the IDE interface by Ppera?
exxos wrote:So will a IDE CF work in TOS 104 with HD8 for example, but the only draw back is it will not boot ? its a little confusing as you mention mega and 206 all in one go..
If 104 will work fine with HD8 and you have a solution then I would be interested in one. I'm not bothered about the boot part really, though unsure exactly what you are saying with patching TOS and it not working with drivers etc..
ppera wrote:You can use Hddriver with internal IDE IF on TOS 1.0x by loading it from floppy. That's all, thank you for your attention
the ones on your site needs patches, cart ports, ASCI port, TOS 206, GAL's, Im NOT talking about all that stuff and going down that road just for the sake of booting from hard drive. I have a STE with Veloce TOS 206, works fine with my SCSI drive. The STFM is what I am looking at, TOS 104 ONLY!
So now thats all clear, has anyone developed a internal IDE such as listed on joogn's site ? or actually built that one ?
ppera wrote:In almost any case I was forced to design myself component for library in Eagle...
exxos wrote:On JP1, where is CER & ROE go ?
Also, are the numbers correct on the CPU on your sch ? Pin 55 is not A23 its D14.. These pin out problems have to be sorted out first Saying that I think this is for the STE CPU so probable you used the PLCC pinout....
Users browsing this forum: No registered users and 5 guests