Kroll wrote:Could you you write me more information, How did you do that ? I use 16 cm ribbon cable to my IDE2SD adapter
Kroll wrote:Unfortunately, but it was only a partial success, the problem began to repeat, very often if in mode 060 the system will crash and after reboot it is the same again. My colleague will tell me the idea that this is a virus, but I doubt it very much.
It will be necessary to return probably to the subject of aluminum foil insulation.
I am thinking about a power problem, if the 3.5 IDE HDD connection does not have this problem (in this case I am using the external ATX power supply).
I just wanted to add maybe this is the reason?
Normally I use the PICOPSU power supply from which the FDD, CT63 and additional PCI board are powered (I have a modified and I do not use 3.3V at all) and the motherboard powers the IDE2SD.
I used thre OCI cards: Radeon, Realtek, and NEC USB card
Does anyone have any idea yet?
dhedberg wrote:I would begin with shielding the cable and see if that helps. It's simple and will not do any harm, only improve things.
Users browsing this forum: No registered users and 5 guests