I don't know why I have such bad luck in Australia when it comes to CT60 but here we go again.
Few days ago my girlfriend brought me my SuperVidel + Svethlana from Slovakia so you can imagine my excitement to try it out, I even started looking for DVI splitters and whatnot. So... I put the SV on the CT60e, make sure everything is all right, power on, CT60 boot screen, AUTO ... and bus error when executing WDIALOG.PRG, great. Few experiments with the J7 jumper, 030/060 mode, nothing special but I couldn't get it working in 060 mode, bus errors everywhere.
So I was like OK, let's remove the SV so I have at least the CT60e working and figure out what to do next. So I removed it and after that, all hell broke loose -- the CT60e wouldn't work anymore. Or, to be precise, wouldn't work after the CPU detection.
First boot (power cycle) looks like this (always):
Pushing reset after that leads to all sorts of colourful images:
030 mode works OK so the most logical explanation would be that I have damaged something on the CT60e during SV removal. But what? It nearly looks like SDRAM detection is the place where it halts (or is Atari logo shown first?) I guess nobody has seen anything like this?
P.S. I even tried to insert the SV again and nope, no bus errors this time, same behaviour on both VGA and DVI outputs.
You do not have the required permissions to view the files attached to this post.
Last edited by mikro
on Tue May 16, 2017 8:30 am, edited 1 time in total.