Dal wrote:Hmmmm I just see New Boot /Old Boot (what's the difference?!?) options.
There are two IDE channels there 0.0 (internal primary?) and 1.0 (CTPCI primary?).
These aren't switchable per-sé but you can effect the order so that the one you wish to boot from is polled first. I can't really see anything else in the CPX that looks relevant.
I also reset the NVRAM in case this has an effect - it didn't.
The strange thing is, if I just have a drive connected to the internal Falcon IDE and boot, it seems to be present on both IDE channels but I see an error (see pic). So I think there is something squiffy with the IRQ. I tested continuity between the through hole on CTPCI before the IRQ pad and U25-pin1 and it seems ok. Perhaps the IRQ isn't changing state properly...
Dal wrote:For me, this is where I encountered an issue as I have the SuperVidel which requires flash 1.03c. Added to this, even if Didier's flash v2.xx was SV-friendly, stacking the CTPCI+SuperVidel+EtherNAT on a CT63 means compromising on speed to make it stable.
1st1 wrote:What is TOS 2.01? TOS 2.x on Falcon?
By the way, I would love to have an addon card for my Falocn which includes SuperVidel, CT-IDE (part of the CTPCI) and network card.
Users browsing this forum: No registered users and 1 guest