TeX38 wrote:Hi all,
I began my Atari trip during the 80's with a big break until about a year ago when I discovered emulators.
I was lucky?? enough to get hold of an old Atari 520 STF that is working in Hi res but I do not have a monitor so can't use Low/Med res.
I purchased the correct modulator for it but it still refuses to display.
Seeing as it was an STF I assumed I would only need to remove a few components to allow the modulator to solder into its place and have done that but sadly still no picture.
Have I missed something, is there anything else I need to do/Remove, jumpers required??
There is a resistor looking thing soldered across the 13pin socket area on the back of the board, is this something that will prevent it working and should I remove it or move it??
I hope someone can help with this as I'm looking forward to getting my ST up and going.
Users browsing this forum: No registered users and 3 guests