It's been a while since my Atari TT was last hooked up. I've got an Atari network adapter in the VME slot and this is all working great with MiNT, but I'm wanting to use my Nova graphics adapter in the VME slot instead.
I've also got a Mac SCSI to Ethernet adapter, which I've confirmed works fine on a Beige G3 Mac. I thought I may be able to get this to work on my Atari using the SCSI/Link drivers I've downloaded for MiNT from http://www.anodynesoftware.com/ethernet/main.htm
. It's a Farallon EtherMac MicroSCSI with firmware v1.1 and it is detected by HDDriver, but the network driver doesn't recognise it on boot. Does anyone know if the drivers on Anodyne Software's page might support this adapter?
Is there any source code available for the driver, perhaps the driver could be amended to add support for this adapter, of course I'm assuming it's using the same SCSI/Link protocol? It appears have the same Zilog CPU, RAM and a ROM as the DaynaPORT, but the main networking chip appears to be an MX98902QC, so it's a little different inside to the photos on here of one of the DaynaPORT adapters; http://goughlui.com/2013/07/28/tech-flashback-daynaport-scsilink-t/