muguk wrote:Upload the software to here and I'm sure someone will lend a hand
stevenlee1 wrote:Yeah, it does sound like a pain to dissassemble. I'm not real good at 68k asm, because I suck at programing. I prefer hardware. Software is just a necessary evil. Really all I'd need is to find out how the program reads the card. And that can't be hard because the cartrige port only reads data.
simonsunnyboy wrote:As the cartridge port is readonly you will only see "read" commands for it.
"Writes" to the cartridge port are achieved by reading a special address (in the address range of the cartridge). A part of the address you are reading from, will encode the byte to send over.
Users browsing this forum: No registered users and 3 guests