Back in the late of summer, CJ and his mate popped across to install an internal 2-Gig drive ...
Full story here: http://www.atari-forum.com/ftopic4610.html
.... to cut a long story short, went away with my old MegaST and h/drive and left me with my eBay purchase of the MegaSTE and the external SCSI drive.
But, during the attempt to boot up off the h/drive after they'd left, the floppy drive won't read disks properly and nor will the h/drive boot off it's own.
So I finally found a few minutes to open the case and I'm looking at the cable which ends up @ jumper 290 (2 pins) on the board with jumper 291 underneath (3 pins).
Which set of pins should this jumper be connected to out of the 5 available as depicted in my naff ASCII art of the pin layout
x * * (290)
* * * (291)
(x is a blank bit - couldn't get the pic aligned otherwise)
I've currently got it connected to pins 290 going horizontal.
Any ideas as want to get my system up and running again.
My main site: http://www.mug-uk.co.uk
- slowly digging up the bits from my past (and re-working a few): Atari ST, Sega 8-bit (game hacks) and NDS (Music ripping guide).
I develop a free Word (for Windows) add-in that's available for Word 2007 upwards. It's a fix-it toolbox that will allow power Word users to fix document errors. You can find it at: http://www.mikestoolbox.co.uk