Thank you for your quick response and your great job.
YES! it works, if i am not solder USB (ID) voltage at the plug.
For power supply I would have only one more question:
It is certainly not good if you have too little voltage , but it is certainly not good if you have too much Voltage (5V DC).
How do you estimate the limits?
Once for the DE10 board and once for the USB board?
Are 4.7V rather bad or still ok? (for example at the MISTER)
Are 5,3V on the USB board rather too much and can make problems?
May the voltage on the USB board be higher than on the MISTER board? (with two different power supplies)
Thanks and regards