Introducing a new 3D printed case for the MiSTer: Case Universal v5.2
I remixed the original Universal Case for the MiSTer to now support the I/O-Board 5.2 .
The I/O-Board 5.2 now features a second SD-card slot and a protruding SoG switch rendering the older Case Universal 1.2 version obsolete.
The new case has new asymmetric connector points between top and bottom shell. It has new cutouts for SD-card slot, SoG switch and the a wider VGA connector. The fan now is mounted directly on the I/O-board PCB. Therefore the fan mounts are now omitted. To increase air flow the vents on the top have been drastically enlarged.
To cover the side cutouts for the SoG and SOD-card slot there are separate plugs available as covers.
Another feature are the three integrated buttons allowing to press the I/O-boards tactile switches while the case is closed. The buttons are printed in place. Should they not move after the print, try using little force to break them free. I tested the print with 0,18mm layer height and 2 outer shells.
For those not interested in external buttons find a top shell file **without buttons**:
The original screws of the DE10 Nano can again be used to fix the DE10 Nano inside the case (see pictures). If you find this to be too difficult try using sharp screws to prepare the holes. It works!
All 3D files are available on thingiverse and can be used without restriction.https://www.thingiverse.com/thing:2684660https://youtu.be/8uKF6L_AuVg
You do not have the required permissions to view the files attached to this post.