Following a post by karabasbarabas (here : http://www.atari-forum.com/viewtopic.php?f=101&t=24583&start=1650#p278484
) and thanks to him for the design of a MIST skin, I tried to do it for my little machine.
Results are not as good as they could have been, my blade was not the best to cut all the holes correctly and I stil have to give it a better finish.
Of course, the best would be to print the design directly on metal, but I do not know if it could be feasible by the factory Lotharek is working with (it would be more precise and even better looking).
Anyway, some pictures here :
I ordered the skin at www.skinit.com
on a generic 13" Laptop skin.
You do not have the required permissions to view the files attached to this post.
1040 STF (TOS 1.02 FR) - 520 STE (TOS 1.62 FR + 4 Mb) - Falcon 030 (TOS 4.04 FR) - MIST