News, Support and Development discussions relating to SuperVidel.

Moderators: Mug UK, moondog/.tSCc., [ProToS], lp, instream, Moderator Team, Nature

Posts: 1
Joined: Mon May 14, 2012 8:31 am


Postby zoon » Fri Aug 23, 2013 9:57 am

Hi there,

unfortunately i started the for supervidel in 030mode and that left me with a dead SuperVidel.
Does anybody here know how to update the SuperVidel with the XilinX programmer and has the needed file for it?
I've tried to contact the guys from nature without any replies.
Probably somebody has the same problem.


Posts: 8
Joined: Sat Jan 07, 2012 9:38 am

Re: SuperVidel+Xilinx

Postby pixben » Fri Aug 23, 2013 2:26 pm

must be run in 060 mode ? :coffe:

Captain Atari
Captain Atari
Posts: 273
Joined: Fri Jan 15, 2010 11:59 pm
Location: Lyman, Maine USA

Re: SuperVidel+Xilinx

Postby mdivancic » Fri Aug 23, 2013 9:29 pm

pixben wrote:must be run in 060 mode ? :coffe:

Correct. Must be run in 060 mode.
Atari Falcon 030, CT-63 w/128MB @ 76MHz, 14 MB RamGizmo, SuperVidel + SvethLANa
Atari TT030, CaTTamaran, 4 MB ST-Ram, 16 MB TT-RAM, ECL2VGA
Amiga 4000T (QuickPak), OS 3.9, QuickPak 060 w/128 MB, Picasso IV, A2065, AD516
Commodore 128D, 1084S monitor, RAMLink, CMD 4.1GB Hardrive
Commodore SX-64

Posts: 173
Joined: Mon Aug 03, 2009 9:08 am
Location: Göteborg, Sweden

Re: SuperVidel+Xilinx

Postby instream » Sat Aug 31, 2013 10:00 am

Under Downloads on there is a link to SV firmware files in MCS-format. Follow the instructions for updating your CT60 that are in the FAQ section of the SV installation manual, but replace the JTAG cable for the 14pin 2mm pitch cable. Also see the note right beside the Download link for the MCS-files.

Social Media


Return to “SuperVidel”

Who is online

Users browsing this forum: No registered users and 4 guests